Load Relay Modeling

See Also

 

For more detail on specific models, see the Transient Stability Block Diagram PDF document. This help topic describes the general behavior of these models.

 

Load Relay Models in Simulator are allowed to apply to either a load, bus, owner, zone, area, or the entire system. During the dynamic simulation, a particular load record will automatically compile a list of all the load relay models that are active looking through the hierarchy as follows.

• All active load-specific models will be added to the list
• All active bus-specific models will be added to the list
• All active owner-specific models will be added to the list
• All active zone-specific models will be added to the list
• All active area-specific models will be added to the list
• All active system-specific models will be added to the list

For more detail on specific models, see the Transient Stability Block Diagram PDF document.